ENGINE NOT RUNNING – Vertical position –
To flush the water passages, you must obtain an optional flushing attachment from your authorized Suzuki Marine Dealer.
- Remove the flush plug and install the flushing attachment (1).
Connect a garden hose to the flushing attachment.
Turn on the water to obtain a good water flow. Flush the engine for about five minutes.
Turn off the water.
Remove the hose and flushing attachment then reinstall the plug into the flushing port.
Leave the motor in a vertical position until the engine is drained completely.
ENGINE NOT RUNNING – Full tilt up position –
Raise the engine to the full tilt up position.
Follow the “ENGINE NOT RUNNING – Vertical position” instructions.
DO NOT RUN ENGINE IN THE FULL TILT UP POSITION.Lower the motor to a vertical position until the engine is drained completely.
SUBMERGED MOTOR
If your motor has been accidentally submerged in water, it must receive a special repair service as soon as possible to prevent corrosion. If possible, have a qualified marine dealer service the engine. If immediate servicing is not available, take the following steps to help protect your motor. In the event that your motor is accidentally submerged, take the following steps:
Get the motor out of the water as soon as possible.
Remove the engine cover and immediately wash the engine thoroughly with fresh water to completely remove all salt, mud, and seaweed.
Remove the spark plugs. Drain the water from the cylinders through the spark plug holes by manually turning the flywheel several times.
Check if any water is evident in the engine oil. If water is seen, remove the oil drain plug and drain the oil. After draining, tighten the oil drain plug.
Drain the fuel line, the carburetor and all filters.
Keep flames and sparks away from gasoline. Dispose of unwanted fuel properly.
- Pour one tablespoon of engine oil in through each spark plug hole and into the carburetor. Coat the engine inner parts with oil by turning the engine over with the recoil starter.
If you encounter friction or resistance while cranking the engine, stop at once and do not attempt to start the engine until it is inspected or repaired.
- Have your authorized Suzuki marine dealer inspect the engine as soon as possible.
If the boat’s fuel tank filler and vent were also submerged, the fuel supply could be contaminated and should be inspected.